November meeting: Campbell Island (ZL3HV) and Bio of Trevor King (ZL2AKW)

Our next Branch meeting is scheduled for Sunday 15 November, from 1pm – 3pm at the Waitohi Centre (Johnsonville Library).

Peter Fisher ZL3HV will speak on his experiences on Campbell Island (including no doubt his encounters with these sea mammals) and his amateur experiments there a few years ago.

Trevor King ZL2AKW will also give an autobiography drawing on his life experience and how amateur radio was interwoven into this. Trevor was originally to give his talk a couple of months ago, but this was interrupted by a return to Level 2 with the Covid-19 outbreak in Auckland.

All are welcome to attend our meetings. The Club will provide tea or coffee in the café upstairs after the meeting for members and guest speakers.

Note that there will be no shed workshop in November or December 2020. A new round of shed workshops will kick off in February 2021.

18 October Meeting – Blackwood Cup Competition

Blackwood Cup – in its 90th year

Our Sunday 18 October meeting (from 1pm – 3pm) at Waitohi (Johnsonville Community Centre) featured our annual Blackwood Cup competition. This was the 90th year of the cup being awarded, so it has a long history. There were only three entries this year, but the winner as voted by members was John ZL2JPM for his QRP three unit combination.

One of those winners from 1974, Derek ZL2AKS, asked the club to dispose of his equipment, as he is moving out of town to a retirement village and will not be operating on HF any more. Bernard ZL2BD oversaw the sale of this equipment. A list of equipment was sent to members. We celebrate Derek’s long-term commitment (60 years) as a member of the club.

We held a moments silence for Don ZL2BL, who became a Silent Key earlier in the month.

Ian ZL2HUT also gave a presentation on Radio Spectrum Management. Ian explained how the radio spectrum is managed, via various legislation, policies, regulations and rules.  

4 October Shed Workshop

Wellgood loop – a broadband RX only loop

Our recent shed workshop on 4 October was held at Bernard ZL2BD’s QTH at 1 Winsley Tce, Churton Park.

RX Only Magnetic Loops

The workshop summarised further RX Magnetic Loop experiments undertaken by Bernard ZL2XJ and answered the following questions.

Is a broadband RX loop as good as a tuned loop?

No. A tuned loop results in around 6dB better signal/noise ratio and will allow you to hear stations that cannot be heard on a broadband RX magnetic loop antenna. However, the broadband loop has its place in that re-tuning is not required (e.g. in a remote SDR receiver situation). It may also be difficult to tune a single loop across a broad spectrum (e.g. 150kHz to 30MHz).

Do you still get an advantage in using a phasing device to null out noise?

Yes. Phasing two RX antennas will also give you an additional lift in Signal/Noise Ratio.

Would a RX only loop be better than a TX loop for most amateur operators?

A TX loop if designed and built correctly can approach or equal the performance of typical amateur low band antennas (e.g. for 160m and 80m) that will necessarily be sub-optimal in height above ground in urban and sub-urban situations. However, a TX magnetic loop is more demanding to build and an RX loop with a TX/RX switch may be a better solution for most amateur operators.

What do RX loops look like?

The loop above is a broadband loop that will be deployed this summer by RemoteDX in an SDR receiver.

How big does an RX loop need to be to cover100kHz to 30mHz?

Around 600mm to 2 metres in diameter depending on which frequencies you want to cover.

40m TX Magnetic Loop

Bernard also indicated, in following up a comment from Bob ZL2CA in relation to the 40m transmitting magnetic loop, recommends instead of using wire (as demonstrated in the August shed workshop) to connect a fixed capacitor to the plates of the butterfly capacitor it would be better to use copper straps or to add fixed plates to the capacitor. The reason is that a fixed capacitor will carry the majority of the current in a loop (up to 60 amps).

RemoteDX SDR Receiver Project

Bernard outlined in more detail, what was entailed in the RemoteDX Inc SDR receiver project. Documentation will be provided at a later date on the remotedx.nz website. The committee is busy progressing project planning.

Used equipment for sale

Derek ZL2AKS, a long-term member of the club (over 60 years) has asked the club to dispose of quite a collection of used equipment. Bernard ZL2BD is organising the equipment for sale to members, and disposal on TradeMe where there is no interest from members in remaining items. The equipment includes two rarely sighted Yaesu FT One transceivers from the early to mid-1980s. Enquiries to Bernard to view.

Training session on OpenGD77 firmware

Radioddity GD77

Mike ZL1AXG, following the afternoon tea break, provided a training session to attendees in the use of OpenGD77 on Radioddity GD77 and Baofeng 1801/860 handheld transceivers. The meeting concluded around 4.30pm.

Wellington VHF Group 50th Anniversary Dinner/Regular Meeting

With the return to level 1 this week, Wellington VHF Broup (Branch 74 NZART) is going to have its 50th celebration dinner at 6:30 pm at the meeting room in Tawa Community Centre on Thursday 24 September.

They will have a few pizzas, but members and visitors should feel free to bring something to eat. Soft drinks, tea and coffee will be provided, but you can bring anything else you like.

This will be followed by their regular main meeting and special guest speaker, Shalini Divya who will be giving a presentation on her research into Aluminium-ion batteries.